- HOME
- 기술정보
- 장비
장비
장비 및 시설 기본정보
초원심분리기
장비 개요
| 기관명 | ZEUS |
|---|---|
| 장비번호 | |
| 제작사 | Beckman Coulter |
| 모델명 | Optima L-90K |
| 장비사양 | |
| 취득일자 | 2005-08-01 |
| 취득금액 |
보유기관 및 이용정보
| 보유기관명 | 건국대학교 산학협력단 |
|---|---|
| 보유기관코드 | |
| 활용범위 | |
| 활용상태 | |
| 표준코드 | B301 |
| 표준분류명 | |
| 시설장비 설명 | - Imbalance-tolerant drive allows visual balancing of rotor loads and eliminates the need for operators to weigh individual samples. - Air-cooled drive and thermoelectric heating/cooling system use no chlorofluorocarbons. - Optima L Series performs common calculations such as CsCl speed reductions run conversions and more. - ESP Efficient Sedimentation Program simulates separations to optimize run times. - Optima micro-ultracentrifuge models let you personalize your work space by repositioning these instruments wherever there is a standard electrical outlet. - For work with biohazards HEPA filter kits are available for all Optima series instruments.Height: 120.7 cm (47.5 in) Width: 94.0 cm (37 in) Depth: 67.3 cm (26.5 in) Weight: 465 kg (1025 lb) Approximate Acceleration Time: Selection from two profiles: maximum acceleration from 0 rpm to set speed or slow acceleration from 0 to 500 rpm followed by maximum acceleration to set speed Approximate Deceleration Time: Select from three profiles: full dynamic braking to 0 rpm slow (full brake to 500 rpm followed by reduced braking to a gentle stop) or no brake Electrical Requirements: 50 Hz 220 to 240 VAC 20 A; 50/60 Hz 200 to 240 VAC 20 A Maximum Heat Dissipation into Room under Steady-State Conditions: 1.0 kW (3400 Btu/hr) Noise Level 1 Meter in Front of Centrifuge: 57 dBA Set Speed: Actual rotor speed ± 20 rpm of the set speed (above 1000 rpm) Set Temperature: 0 to 40°C in increments of 1°C Set Time: Up to 99 hr and 59 min; HOLD for runs of unspecified length Speed Range: 1000 rpm to maximum speed Temperature Control: ± 0.5°C of set temperature; within 0.3°C of set after equilibration Clearances Required: 5.1 cm (2.0 in) sides; 15.2 cm (6.0 in) rear Door: 17.5 mm (0.69-in) high-strength structural steel Humidity Restrictions: < 95% (non-condensing) Pollution Degree: 2 Time -- Actual Display: Indicates time remaining in timed runs time elapsed in Hold runs or estimated time remaining in Ω2t runs Vacuum: Diffusion pump in series with a mechanical pump typically reduces chamber pressure to below 5 μ (0.7 Pa) Finish: Urethane paint on top surface; general-purpose paint on other surfaces; coated polycarbonate finish on control panel Operating Modes: Standard programmed or delayed start; instrument memory can store up to nine programs. Key switch selects NORMAL or ZONAL operation. Barrier Ring: 41 mm (1.63-in) heat-treated steel alloy armor ring surrounded by a 12 mm (0.50-in) steel vacuum chamber to provide full protection for the operator Instrument Classification: S: uses all Beckman Coulter preparative rotors except Types 35 and 42.1 rotors고밀도의 사카로오스액(液)에 현탁(懸濁)한 세포파쇄물을 초원심분리하고 세포 내 과립(顆粒)의 작은 밀도차를 이용하여 핵 등을 정제분획(精製分劃)하거나 염화세슘용액을 사용하여 핵산을 부유밀도차(浮遊密度差)로 분획하는 데도 쓰인다. |
| 장비이미지코드 | http://nfec.ntis.go.kr/storage/images/equip/photo/201107/.thumb/20110721121049.jpg |
| 장비위치주소 | 서울특별시 광진구 능동로 120 건국대학교 동물생명과학관 4층 422-1 |
| NFEC 등록번호 | NFEC-2011-07-146443 |
| 예약방법 | |
| 카타로그 URL | |
| 메뉴얼 URL | |
| 원문 URL | http://www.zeus.go.kr/equip/read?equipId=Z-NTIS-0029500 |
| 첨부파일 |
추가정보
| 과학기술표준분류 | |
|---|---|
| ICT 기술분류 | |
| 주제어 (키워드) |